Here comes another new boxmod from Kangside. This time it’s a powerful boxmod for 3 18650 batteries designed for 230 W and running on the board from YiHi. Most likely, it will take the place of the company’s flagship.
The design of its shape resembles the RX200, but blame the company for this has long ceased, because this shape is ideal for 3 batteries, it is hard to argue with this. Otherwise, the design of the boxmod is very boring, so much so that I’m too lazy to describe everything to you, just look at the picture. The boxmod is available in three colors black, red and blue.” The size of the boxmod is as follows: 100x52x42.
As I said in the beginning, the board used in the boxmod from YiHi, and more specifically SX345. It has the following characteristics: maximum power 230W, minimum resistance 0.1 ohm, in thermocontrol mode 0.05ohm at 100-300C or 212-572F. aspire vape Joules on nickel 10-75J, on titanium 10-100J. Based on the company’s past boxmod on the 3 battery 230 W it will not pull, but 200 I think it can.
The connector is equipped with a spring-loaded center contact. The manufacturer also stated that their boxmod supports atomizers with SX Pure technology.
As I’ve already said several times, the boxmod runs on three 18650 batteries, and you can’t charge it via micro-usb. The connector is only for firmware updates. So you will need to buy a separate charger.
Well, I think I’ve told you everything and we can summarize. The price of the boxmod is 40 dollars and I don’t understand why their B80 is almost 2 times more expensive! If the build quality is better than that of the RX200 (I admit, it’s not that difficult to realize), then the boxmod is quite good for such money. Except that you will have to spend a lot on a separate charger.
